Ancon Slot Ties
Ancon PPS/PPB/PPV/PP21 Movement Tie
This is a default meta description. Leviat enhance Nexus® range with launch of Nexus XI 22 Nov 2020. Leading masonry support brand, Ancon, and the UK’s largest brickwork special shape and masonry fabrication company, Ibstock Kevington, have launched Nexus® XI – a new, mechanically fixed brick-faced support system and lintel range - to further enhance the already popular Nexus® offering. Ancon SDB Frame Cramps used as cavity wall ties exceed the requirements of a Type 2 tie to PD 6697 for cavities up to 300mm. They have a 7mm diameter hole to suit a range of fixings. Ancon M6 single expansion bolts are recommended for fixing to concrete and M6 set screws or SDTSS-38-5PT self-drilling screws for fixing to steelwork. The range of standard ties provides a solution for all types of wall construction. Ancon fixings are manufactured from Austenitic stainless steel. Grade 1.4301 (304) is used in the vast majority of applications. Grade 1.4401 (316) is used in severe marine locations. A two-part wall tie for connecting the leaves of cavity wall. One section is built into the blockwork and the other section is fixed as the outer leaf is constructed. Ancon frame ties and channel ties are manufactured with a non-spread safety end allowing the use of a debonding sleeve. This type of safety end reduces the variety of ties required on site. Wall ties should be pressed down in, and then surrounded by, fresh mortar.
Debonding sleeves are used on plain-ended wall ties at vertical movement joints. The tie will restrain the masonry against lateral wind loads but the sleeve will allow the masonry to expand or contract. Debonding sleeves should be installed with a 10mm gap at the end to allow for expansion of the masonry.
Debonding Sleeve
Debonded Ties require 100mm embedment. A 120mm long sleeve will provide an allowance for movement and tolerance, and will be suitable for most applications. Other lengths and sizes available to special order.
Wall Ties & Restraint Fixings (PDF, 6.97 MB)
Ancon Slot Ties Track
Ancon PPS/PPB/PPV/PP21 Movement Tie
Debonding sleeves are used on plain-ended wall ties at vertical movement joints. The tie will restrain the masonry against lateral wind loads but the sleeve will allow the masonry to expand or contract. Debonding sleeves should be installed with a 10mm gap at the end to allow for expansion of the masonry.
Debonding Sleeve
Debonded Ties require 100mm embedment. A 120mm long sleeve will provide an allowance for movement and tolerance, and will be suitable for most applications. Other lengths and sizes available to special order.
